Address Table Commands 79
bridge multicast address
{
mac-multicast-address
|
ip-multicast-address
}
[
add
|
remove
]
{
ethernet
interface-list | port-channel port-channel-number-list
}
no bridge multicast address
{
mac-multicast-address
|
ip-multicast-address
}
•
add
—Adds ports to the group. If no option is specified, this is the default option.
•
remove
—Removes ports from the group.
•
mac-multicast-address
—MAC multicast address in the format of xx:xx:xx:xx:xx:xx.
•
ip- multicast-address
—IP multicast address.
•
interface-list
—Separate nonconsecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
•
port-channel-number-list
—Separate nonconsecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
• If the command is executed without
add
or
remove
, the command only registers the group in
the bridge database.
• Static multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:
The following example registers the MAC address and adds ports statically.
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 01:00:5e:02:02:03
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 01:00:5e:02:02:03
add ethernet g1-9
To Next Page
Loading...
