378 802.1x Commands
www.dell.com | support.dell.com
Default Configuration
30
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
• The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with certain clients
and authentication servers.
Examples
The following example sets the time for the retransmission of an EAP-request frame to the client,
to 3600 seconds.
dot1x timeout server-timeout
The
dot1x timeout server-timeout
Interface Configuration mode command sets the time for the
retransmission of packets to the authentication server. Use the
no
form of this command to return
to the default setting.
Syntax
dot1x timeout server-timeout
seconds
no dot1x timeout server-timeout
•
seconds—
Time in seconds that the switch should wait for a response from the
authentication server before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
• There are no user guidelines for this command.
console config-if(Config-VLAN)# dot1x timeout supp-timeout 3600
To Next Page
Loading...
