Dell PowerConnect 5324 Command Line Interface Reference Manual

186 LLDP Commands
www.dell.com | support.dell.com
Command Modes
Privileged EXEC
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the Link Layer Discovery Protocol (LLDP) information that is
advertised from a specific port.
show lldp neighbors
To display information about neighboring devices discovered using Link Layer Discovery Protocol
(LLDP), use the
show lldp neighbors command in privileged EXEC mode.
Syntax
show lldp neighbors [ethernet interface]
•
Interface — Ethernet port
Command Modes
Privileged EXEC
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays information about neighboring devices discovered using Link Layer
Discovery Protocol (LLDP).
Switch# show lldp local ethernet g1
Device ID: 0060.704C.73FF
Port ID: 1
Capabilities: Bridge
System Name: ts-7800-1
System description:
Port description:
Management address: 172.16.1.8

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2