Dell PowerConnect 5324 Command Line Interface Reference Manual

Command Groups 41
switchport access vlan Configures the VLAN membership mode of a port. Interface
Configuration
switchport access vlan Configures the VLAN ID when the interface is in access
mode.
Interface
Configuration
switchport trunk
allowed vlan
Adds or removes VLANs from a port in general mode. Interface
Configuration
switchport trunk native
vlan
Defines the port as a member of the specified VLAN, and
the VLAN ID is the "port default VLAN ID (PVID)".
Interface
Configuration
switchport general
allowed vlan
Adds or removes VLANs from a general port. Interface
Configuration
switchport general pvid Configures the PVID when the interface is in general
mode.
Interface
Configuration
switchport general
ingress-filtering disable
Disables port ingress filtering. Interface
Configuration
switchport general
acceptable-frame-type
tagged-only
Discards untagged frames at ingress. Interface
Configuration
switchport forbidden
vlan
Forbids adding specific VLANs to a port. Interface
Configuration
map protocol
protocols-group
Adds a special protocol to a named group of protocols,
which may be used for protocol-based VLAN assignment.
VLAN
Configuration
switchport general map
protocols-group vlan
Sets a protocol-based classification rule. Interface
Configuration
ip internal-usage-vlan
Reserves a VLAN as the internal usage VLAN of an
interface.
Interface
Configuration
show vlan Displays VLAN information. Privileged User
EXEC
show vlan internal
usage
Displays a list of VLANs being used internally by the
switch.
Privileged User
EXEC
show vlan protocols-
groups
Displays protocols-groups information. Privileged User
EXEC
show interfaces
switchport
Displays switchport configuration. Privileged User
EXEC
switchport mode Configures the VLAN membership mode of a port Interface
configuration
(Ethernet, port-
channel)

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2