Command Modes 49
dot1x max-req Sets the maximum number of times that the switch sends an EAP -
request/identity frame to the client, before restarting the authentication
process.
show dot1x Allows multiple hosts on an 802.1X-authorized port, that has the dot1x
port-control interface configuration command set to auto.
dot1x port-control Enables manual control of the authorization state of the port
dot1x re-authentication Enables periodic re-authentication of the client.
dot1x single-host-violation Configures the action to be taken, when a station whose MAC address is
not the supplicant MAC address, attempts to access the interface.
dot1x timeout quiet-period Sets the number of seconds that the switch remains in the quiet state
following a failed authentication exchange.
dot1x timeout re-authperiod Sets the number of seconds between re-authentication attempts.
dot1x timeout server-timeout Sets the time for the retransmission of packets to the authentication
server
dot1x timeout supp-timeout Sets the time for the retransmission of an EAP-request frame to the
client.
dot1x timeout tx-period
Sets the number of seconds that the switch waits for a response to
an Extensible Authentication Protocol (EAP) - request/identity
frame, from the client, before resending the request.
show dot1x Sets the number of seconds that the switch waits for a response to an
EAP request/identity frame, from the client, before resending the
request.
duplex Configures the full/half duplex operation of a given ethernet interface
when not using auto-negotiation.
flowcontrol Configures the Flow Control on a given interface.
garp timer Adjusts the GARP application join, leave, and leaveall GARP timer
values.
gvrp enable (interface) Enables GVRP on an interface.
gvrp registration-forbid De-registers all VLANs, and prevents dynamic VLAN registration on the
port.
gvrp vlan-creation-forbid Enables or disables dynamic VLAN creation.
ip address
Sets an IP address
ip address dhcp Acquires an IP address on an interface from the DHCP server.
ip internal-usage-vlan
Reserves a VLAN as the internal usage VLAN of an interface.
lacp port-priority Configures the priority value for physical ports.
lacp timeout Assigns an administrative LACP timeout.
mdix Enables automatic crossover on a given interface.
To Next Page
Loading...
