Command Line Interface
10411553-KDU 137 365 Uen D 2006-06-16
Default Setting
No neighbors are defined.
Command Usage
This command can be used to configure a static neighbor with which this
router will exchange information, rather than relying on broadcast messages
generated by the RIP protocol.
Example
7.26.11 version
This command specifies a RIP version used globally by the router. Use the no
form to restore the default value.
Syntax
version {1 | 2}
no version
• 1 - RIP Version 1
• 2 - RIP Version 2
Command Mode
Router Configuration
Default Setting
RIP Version 1
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#
To Next Page
Loading...
