Command Line Interface
1042 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
• When this command is used to specify a global RIP version, any VLAN
interface not previously set by the ip rip receive version or ip
rip send version command will be set to the following values:
• RIP Version 1 configures the unset interfaces to send RIPv1
compatible protocol messages and receive either RIPv1 or RIPv2
protocol messages.
• RIP Version 2 configures the unset interfaces to use RIPv2 for both
sending and receiving protocol messages.
• When the no form of this command is used to restore the default value,
any VLAN interface not previously set by the ip rip receive
version or ip rip send version command will be set to the
default send or receive version.
Example
This example sets the global version for RIP to send and receive version 2
packets.
Related Commands
ip rip receive version (section 7.26.12 on page 1043)
ip rip send version (section 7.26.13 on page 1044)
Console(config-router)#version 2
Console(config-router)#
To Next Page
Loading...
