Configuring the ECN330-switch
1011553-KDU 137 365 Uen D 2006-06-16
CLI – This example shows the event message stored in RAM.
6.3.13.4 Sending Simple Mail Transfer Protocol Alerts
To alert system administrators of problems, the ECN330-switch can use SMTP
(Simple Mail Transfer Protocol) to send email messages when triggered by
logging events of a specified level. The messages are sent to specified SMTP
servers on the network and can be retrieved using POP or IMAP clients.
Command Attributes
• Admin Status – Enables/disables the SMTP function.
(Default: Enabled)
• Email Source Address – Sets the email address used for the “From”
field in alert messages. Use a symbolic email address that identifies the
ECN330-switch, or the address of an administrator responsible for the
ECN330.
• Severity – Sets the syslog severity threshold level (see the table on
page 97) used to trigger alert messages. All events at this level or higher
will be sent to the configured email recipients. For example, using Level
7 will report all events from level 7 to level 0. (Default: Level 7)
• SMTP Server List – Specifies a list of up to three recipient SMTP
servers. The ECN330-switch attempts to connect to the other listed
servers if the first fails. Use the New SMTP Server text field and the Add/
Remove buttons to configure the list.
• Email Destination Address List – Specifies the email recipients of
alert messages. Specify up to five recipients. Use the New Email
Destination Address text field and the Add/Remove buttons to configure
the list.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
To Next Page
Loading...
