Command Line Interface
11091553-KDU 137 365 Uen D 2006-06-16
Command Mode
Global Configuration
Command Usage
This command enables DVMRP globally for the router and enters router
configuration mode. Make any changes necessary to the global DVMRP
parameters. Then specify the interfaces that will support DVMRP multicast
routing using the ip dvmrp command, and set the metric for each interface.
Example
Related Commands
ip dvmrp (section 7.27.10 on page 1115)
show router dvmrp (section 7.27.13 on page 1117)
Console(config)#router dvmrp
Console(config-router)#end
Console#show router dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 0
Console#
To Next Page
Loading...
