Command Line Interface
11111553-KDU 137 365 Uen D 2006-06-16
7.27.5 nbr-timeout
This command sets the interval to wait for messages from a DVMRP neighbor
before declaring it dead. Use the no form to restore the default value.
Syntax
nbr-timeout <seconds>
no nbr-timeout
seconds - Interval before declaring a neighbor dead. (Range: 1-65535)
Default Setting
35 seconds
Command Mode
Router Configuration
Command Usage
This command is used for timing out routes, and for setting the children and
leaf flags.
Example
Console(config-router)#nbr-timeout 40
Console(config-router)#
To Next Page
Loading...
