Ericsson ECN330 - Page 1119

Command Line Interface
11131553-KDU 137 365 Uen D 2006-06-16
Default Setting
5 seconds
Command Mode
Router Configuration
Example
7.27.8 prune-lifetime
This command specifies how long a prune state will remain in effect for a
multicast tree. Use the no form to restore the default value.
Syntax
prune-lifetime <seconds>
no prune-lifetime
seconds - Prune state lifetime. (Range: 1-65535)
Default Setting
7200 seconds
Command Mode
Router Configuration
Command Usage
This command sets the prune state lifetime. After the prune state expires,
the router will resume flooding multicast traffic from the multicast source
device.
Console(config-router)#flash-update-interval 10
Console(config-router)#