Ericsson ECN330 - Page 1128

Command Line Interface
1122 1553-KDU 137 365 Uen D 2006-06-16
PIM-DM Multicast Routing Commands
This section describes commands used to configure PIM-DM dynamic multicast
routing on the ECN330-switch.
Table 151 PIM-DM Multicast Routing Commands
Command Function Mode Page
router pim dense-
mode
Enables PIM-DM globally for the router GC 1123
ip pim dense-mode Enables PIM-DM on the specified interface IC 1124
ip pim hello-
interval
Sets the interval between sending PIM-DM hello
messages
IC 1125
ip pim hello-
holdtime
Sets the time to wait for hello messages from a
neighboring PIM-DM router before declaring it
dead
IC 1126
ip pim trigger-
hello-interval
Sets the maximum time before sending a
triggered PIM-DM Hello message
IC 1127
ip pim join-
prune-holdtime
Configures the hold time for the prune state IC 1128
ip pim graft-
retry-interval
Configures the time to wait for a Graft
acknowledgement before resending a Graft
message
IC 1129
ip pim max-graft-
retries
Configures the maximum number of times to
resend a Graft message if it has not been
acknowledged
IC 1130
show router pim Displays the global PIM configuration settings NE,
PE
1130
show ip pim
interface
Displays information about interfaces configured
for PIM
NE,
PE
1131
show ip pim
neighbor
Displays information about PIM neighbors NE,
PE
1132