Command Line Interface
1134 1553-KDU 137 365 Uen D 2006-06-16
PIM-SM Multicast Routing Commands
This section describes commands used to configure PIM-SM dynamic multicast
routing on the ECN330-switch.
Table 153 PIM-SM Multicast Routing Commands
Command Function Mode Page
router pim
sparse-mode
Enables PIM-SM globally for the router GC 1136
ip pim
jp-interval
Sets the join/prune timer GC 1137
ip pim
bsr-candidate
Configures the ECN330-switch as a Bootstrap
Router (BSR) candidate
GC 1138
ip pim
rp-candidate
Configures the ECN330-switch as a
Rendezvous Point (RP) candidate
GC 1141
ip pim rp-address Sets a static address for the Rendezvous Point GC 1144
ip pim register-
rate-limit
Configures the rate at which register messages
are sent by the Designated Router (DR)
GC 1146
ip pim
spt-threshold
infinity
Prevents the last-hop PIM router from switching
to Shortest Path Source Tree (SPT) mode
GC 1147
ip pim register-
suppression
Configures the register suppression timer on a
DR or the keep alive time on an RP
GC 1149
ip pim ignore-
rp-set-priority
Ignores the priority value for RP candidates, and
only uses the hashing mechanism for RP
selection
GC 1150
ip pim crp-prefix Allows the ECN330-switch to be accepted as an
RP candidate by a Cisco BSR
GC 1151
To Next Page
Loading...
