Configuring the ECN330-switch
1091553-KDU 137 365 Uen D 2006-06-16
Web – Click SNMP, Agent Status. Enable the SNMP Agent by marking the
Enabled checkbox, and click Apply.
Figure 33 Enabling the SNMP Agent
CLI – The following example enables SNMP on the ECN330-switch.
6.4.2 Setting Community Access Strings
Up to five community strings can be configured, which authorize management
access by clients using SNMP v1 and v2c. All community strings used for IP Trap
Managers should be listed in this table. For security reasons, consider removing
the default strings.
Command Attributes
• SNMP Community Capability – The ECN330-switch supports up to
five community strings.
• Current – Displays a list of the community strings currently configured.
• Community String – A community string that acts like a password and
permits access to the SNMP protocol.
Default strings: “public” (read/write access), “private” (read/write
access)
Range: 1-32 characters, case sensitive
• Access Mode – Specifies the access rights for the community string:
• Read-Only – Authorized management stations are only able to
retrieve MIB objects.
• Read/Write – Authorized management stations are able to both
retrieve and modify MIB objects.
Console(config)#snmp-server
Console(config)#
To Next Page
Loading...
