Command Line Interface
1158 1553-KDU 137 365 Uen D 2006-06-16
Example
This example sets the hello time on VLAN 1.
Related Commands
show ip pim interface (section 7.27.26 on page 1131)
7.27.42 ip pim hello-holdtime
This command sets the timer that detects whether a neighbor router is still alive
and sending hello messages. Use the no form to restore the default setting.
Syntax
ip pim hello-holdtime <holdtime-value>
no ip pim hello-holdtime
holdtime-value - Holdtime for which to keep a neighbor state alive.
(Range: 1-65535 seconds)
Default Setting
3.5 times the hello interval
Console(config)#interface vlan 1
Console(config-if)#ip pim hello-interval 40
Console#show ip pim interface 1
Vlan 1 is up
PIM is enabled, mode is Sparse.
Internet address is 192.168.1.250.
Hello time interval is 30 sec, trigger hello time interval is 40
sec.
Hello holdtime is 105 sec.
DR priority is 20.
DR Internet address is 0.0.0.0, neighbor count is 0.
Console#
To Next Page
Loading...
