Configuring the ECN330-switch
1211553-KDU 137 365 Uen D 2006-06-16
CLI – Use the snmp-server user command to configure a new user name and
assign it to a group.
6.4.4.5 Configuring SNMPv3 Groups
An SNMPv3 group sets the access policy for its assigned users, restricting them
to specific read and write views. Use the pre-defined default groups or create
new groups to map a set of SNMP users to SNMP views.
Command Attributes
• Group Name – The name of the SNMP group. (Range: 1-32
characters)
• Model – The group security model; SNMP v1, v2c or v3.
• Level – The security level used for the group:
• noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
• AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted (only available for the SNMPv3 security
model).
• AuthPriv – SNMP communications use both authentication and
encryption (only available for the SNMPv3 security model).
• Read View – The configured view for read access. (Range: 1-32
characters)
Console(config)#snmp-server user mark group r&d remote 192.168.1.19
v3 auth md5 greenpeace priv des56 einstien
Console(config)#exit
Console#show snmp user
No user exist.
SNMP remote user
EngineId: 80000000030004e2b316c54321
User Name: mark
Authentication Protocol: none
Privacy Protocol: none
Storage Type: nonvolatile
Row Status: active
Console#
To Next Page
Loading...
