Configuring the ECN330-switch
1291553-KDU 137 365 Uen D 2006-06-16
be specified. Local and remote logon authentication control
management access through the console port, web browser, or Telnet.
• RADIUS and TACACS+ logon authentication assign a specific privilege
level for each user name/password pair. The user name, password, and
privilege level must be configured on the authentication server.
• Up to three authentication methods can be specified for any user to
indicate the authentication sequence. For example, by selecting (1)
RADIUS, (2) TACACS and (3) Local, the user name and password on
the RADIUS server is verified first. If the RADIUS server is not available,
then authentication is attempted using the TACACS+ server, and finally
the local user name and password is checked.
Command Attributes
• Authentication – Select the authentication, or authentication sequence
required:
• Local – User authentication is performed only locally by the
ECN330-switch.
• Radius – User authentication is performed using a RADIUS server
only.
• TACACS – User authentication is performed using a TACACS+
server only.
• [authentication sequence] – User authentication is performed by up
to three authentication methods in the indicated sequence.
• RADIUS Settings
• Global – Provides globally applicable RADIUS settings.
• ServerIndex – Specifies one of five RADIUS servers that may be
configured. The ECN330-switch attempts authentication using the
listed sequence of servers. The process ends when a server either
approves or denies access to a user.
• Server IP Address – Address of authentication server. ServerIndex
must be selected to display this field. (Default: 10.1.0.1)
• Server Port Number – Network (UDP) port of authentication server
used for authentication messages. (Range: 1-65535; Default: 1812)
To Next Page
Loading...
