Configuring the ECN330-switch
134 1553-KDU 137 365 Uen D 2006-06-16
Web – Click Security, HTTPS Settings. Enable HTTPS and specify the port
number, then click Apply.
Figure 45 HTTPS Settings
CLI – This example enables the HTTP secure server and modifies the port
number.
6.5.3.1 Replacing the Default Secure-site Certificate
When using HTTPS (for secure access) to log onto the web interface, a Secure
Sockets Layer (SSL) certificate appears for the ECN330-switch. By default, the
certificate that Netscape and Internet Explorer display will be associated with a
warning that the site is not recognized as a secure site. This is because the
certificate has not been signed by an approved certification authority. To replace
this warning by a message confirming that the connection to the ECN330-switch
is secure, a unique certificate and a private key and password must be obtained
from a recognized certification authority.
Note: For maximum security, it is recommended to obtain a unique Secure
Sockets Layer certificate at the earliest opportunity. This is because the default
certificate for the ECN330-switch is not unique to the hardware.
Console(config)#ip http secure-server
Console(config)#ip http secure-port 441
Console(config)#
To Next Page
Loading...
