Configuring the ECN330-switch
1411553-KDU 137 365 Uen D 2006-06-16
• SSH Authentication Timeout – Specifies the time interval in seconds
that the SSH server waits for a response from a client during an
authentication attempt.
(Range: 1 to 120 seconds; Default: 120 seconds)
• SSH Authentication Retries – Specifies the number of authentication
attempts that a client is allowed before authentication fails and the client
has to restart the authentication process. (Range: 1-5 times; Default: 3)
• SSH Server-Key Size – Specifies the SSH server key size. (Range:
512-896 bits; Default: 768)
• The server key is a private key that is never shared outside the
ECN330-switch.
• The host key is shared with the SSH client, and is fixed at 1024 bits.
Web – Click Security, SSH, Settings. Enable SSH and adjust the authentication
parameters as required, then click Apply. Note that the host key pair must first
be generated on the SSH Host-Key Settings page before the SSH server can be
enabled.
Figure 47 SSH Server Settings
To Next Page
Loading...
