Configuring the ECN330-switch
182 1553-KDU 137 365 Uen D 2006-06-16
6.6.6 Binding a VLAN to an Access Map
After configuring the VLAN access map, bind one or more VLANs that need to
filter traffic to the appropriate access map. Note that a VLAN can only be bound
to one access map.
Command Usage
• A mask must be configured for any access map before it can be bound
to a VLAN.
• Only one VLAN access map can be bound to a VLAN. If more than one
access map is bound to the same VLAN, only the later one will be used.
• When an IP or MAC access list is bound to a port interface, and a VLAN
map is subsequently bound to a VLAN containing that port, the VLAN
access map takes precedence over the port ACL.
Command Attributes
• VLAN Access Map Name – Name of VLAN access map.
(Maximum length: 16 characters)
• VLAN Filter List – A list of one or more VLANs to which the selected
access map is bound. (Range: 1-4094)
To Next Page
Loading...
