Configuring the ECN330-switch
196 1553-KDU 137 365 Uen D 2006-06-16
CLI – The following example enables LACP for ports 1 to 6. Just connect these
ports to LACP-enabled trunk ports on another switch to form a trunk.
6.7.3.3 Configuring LACP Parameters
Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
• Ports must have the same LACP System Priority.
• Ports must have the same LACP port Admin Key.
• However, if the “port channel” Admin Key is set (page 763), then the port
Admin Key must be set to the same value for a port to be allowed to join
a channel group.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port Type: 100TX
Mac Address: 00-00-12-33-89-7F
Configuration:
Name:
Port Admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Flow Control: Disabled
Port Security: Disabled
Max MAC Count: 0
Current status:
Created by: LACP
Link status: Up
Port operation status: Up
Operation Speed-duplex: 100full
Flow Control Type: None
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
To Next Page
Loading...
