Configuring the ECN330-switch
230 1553-KDU 137 365 Uen D 2006-06-16
6.9.3 Changing the Aging Time
The aging time can be set for entries in the dynamic address table.
Command Attributes
• Aging Status – Enables/disables the aging function.
• Aging Time – The time after which a learned entry is discarded.
(Range: 10-1000000 seconds; Default: 300 seconds)
Web – Click Address Table, Address Aging. Specify the new aging time, click
Apply.
Figure 90 Address Aging
CLI – This example sets the aging time to 400 seconds.
6.9.4 Setting an Address Threshold
A trap message can be sent when entries in the address table exceed a
specified threshold.
Command Attributes
• MAC-Address-Table Threshold Status – Sends a trap when entries in
the MAC address table exceed the rising threshold. Note that once this
trap has been sent, the next trigger time for this trap is after the MAC
address entries fall below the falling threshold, and then exceed the
rising threshold again.
Console(config)#mac-address-table aging-time 400
Console(config)#
To Next Page
Loading...
