Configuring the ECN330-switch
294 1553-KDU 137 365 Uen D 2006-06-16
6.12.1.11 Configuring the MAC Address for a VLAN
Use the VLAN MAC Address page to configure the MAC address of any VLAN
on the ECN330-switch.
Command Usage
• It may be necessary to configure a unique MAC address for a VLAN to
ensure proper operation of service provider applications, or to simplify
troubleshooting.
• After configuring a MAC address for a VLAN, all Layer 3 traffic
originating from this VLAN will use the specified MAC address.
• MAC addresses used for VLANs have the following restrictions:
• Cannot be a broadcast MAC address.
• Cannot be a multicast MAC address.
• Cannot be a MAC address or all zeroes.
Command Attributes
• VLAN – ID of configured VLAN. (Range: 1-4094)
• MAC Address – MAC address of the selected VLAN.
(Format examples: 00-01-02-03-0d-0e or 000102030d0e)
• Set Default MAC Address – Sets the MAC address to the same as that
used by the ECN330-switch.
• Set MAC Address – Sets the MAC address to the specified value.
To Next Page
Loading...
