Configuring the ECN330-switch
3131553-KDU 137 365 Uen D 2006-06-16
6.12.3.2 Mapping Protocols to VLANs
Map a protocol group to a VLAN for each interface that will participate in the
group.
Command Usage
• When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. Assigning interfaces using any of the other VLAN
commands, such as VLAN Static Table (page 287) or VLAN Static
Membership (page 289), these interfaces will admit traffic of any
protocol type into the associated VLAN.
• When a frame enters a port that has been assigned to a protocol VLAN,
it is processed in the following manner:
• If the frame is tagged, it will be processed according to the standard
rules applied to tagged frames.
• If the frame is untagged and the protocol type matches, the frame
is forwarded to the appropriate VLAN.
• If the frame is untagged but the protocol type does not match, the
frame is forwarded to the default VLAN for this interface.
Command Attributes
• Interface – Port or trunk identifier.
• Protocol Group ID –
Group identifier of this protocol group.
(Range: 1-2147483647)
• VLAN ID – VLAN to which matching protocol traffic is forwarded.
(Range: 1-4094)
To Next Page
Loading...
