Configuring the ECN330-switch
3791553-KDU 137 365 Uen D 2006-06-16
manually bound to a specific client if required. However, any fixed
addresses must fall within the range of an existing network address
pool. Up to 32 fixed host addresses (that is, entering one address per
pool) can be configured.
• If the DHCP server is running, it must be disabled and then reenabled
to implement any configuration changes. This can be done on the
DHCP, Server, General page.
6.18.2.1 Enabling the Server, Setting Excluded Addresses
Enable the DHCP Server and specify the IP addresses that it should not be
assigned to clients.
Command Attributes
• DHCP Server – Enables or disables the DHCP server on the ECN330-
switch. (Default: Disabled)
• Excluded Addresses – Specifies IP addresses that the DHCP server
should not assign to DHCP clients. A single address or an address
range can be specified.
• New (Excluded Addresses) – New entries for excluded addresses can
be specified as a single address or an address range.
To Next Page
Loading...
