Configuring the ECN330-switch
378 1553-KDU 137 365 Uen D 2006-06-16
CLI – This example specifies one DHCP relay server for VLAN 1, and enables
the relay service.
6.18.2 Configuring the DHCP Server
The ECN330-switch includes a Dynamic Host Configuration Protocol (DHCP)
server that can assign temporary IP addresses to any attached host requesting
service. It can also provide other network settings such as the domain name,
default gateway, Domain Name Servers (DNS), Windows Internet Naming
Service (WINS) name servers, or information on the bootup file for the host
device to download.
Addresses can be assigned to clients from a common address pool configured
for a specific IP interface on the ECN330-switch, or fixed addresses can be
assigned to hosts based on the client identifier code or MAC address.
Figure 159 DHCP Server
Command Usage
• First configure any excluded addresses, including the address for the
ECN330-switch.
• Then configure address pools for the network interfaces. Up to 8
network address pools can be configured. An address can also be
Console(config)#interface vlan 1
Console(config-if)#dhcp relay server 10.1.0.99
Console(config-if)#ip dhcp relay
Console(config-if)#
8 network
address pools
Address
Pool
Static
Addresses
32 static addresses
(all within the confines
of configured network
address pools)
To Next Page
Loading...
