Configuring the ECN330-switch
426 1553-KDU 137 365 Uen D 2006-06-16
Command Attributes
Global Settings
• RIP Routing Process – Enables RIP routing for all IP interfaces on the
router. (Default: Disabled)
• Global RIP Version – Specifies a RIP version used globally by the
router. (Default: RIP Version 1)
Timer Settings
• Update – Sets the rate at which updates are sent. This value will also
set the timeout timer to 6 times the update time, and the garbage-
collection timer to 4 times the update time. (Range: 15-60 seconds;
Default: 30 seconds)
• Timeout – Sets the time after which there have been no update
messages that a route is declared dead. The route is marked
inaccessible (that is, the metric set to infinite) and advertised as
unreachable. However, packets are still forwarded on this route. This
parameter is automatically set to six times the value or the Update timer.
(Default: 180 seconds)
• Garbage Collection – After the timeout interval expires, the router
waits for an interval specified by the garbage-collection timer before
removing this entry from the routing table. This timer allows neighbors
to become aware of an invalid route prior to purging. This parameter is
automatically set to four times the value or the Update timer. (Default:
120 seconds)
To Next Page
Loading...
