Configuring the ECN330-switch
4271553-KDU 137 365 Uen D 2006-06-16
Web - Click Routing Protocol, RIP, General Settings. Enable or disable RIP, set
the RIP version used on previously unset interfaces to RIPv1 or RIPv2, set the
basic update timer, and then click Apply.
Figure 188 RIP General Settings
CLI - This example sets the router to use RIP Version 2, and sets the basic timer
to 15 seconds.
Console(config)#router rip
Console(config-router)#version 2
Console(config-router)#timers basic 15
Console(config-router)#end
Console#show rip globals
RIP Process: Enabled
Update Time in Seconds: 15
Number of Route Change: 0
Number of Queries: 1
Console#
To Next Page
Loading...
