Command Line Interface
5611553-KDU 137 365 Uen D 2006-06-16
Table 40 Flash and File Commands
7.5.14 copy
This command moves (uploads or downloads) a code image or configuration file
between the ECN330-switch’s flash memory and a TFTP server. When the
system code or configuration settings are saved to a file on a TFTP server, that
file can later be downloaded to the ECN330-switch to restore system operation.
The success of the file transfer depends on the accessibility of the TFTP server
and the quality of the network connection.
Syntax
copy file {file | running-config | startup-config | tftp}
copy running-config {file | startup-config | tftp}
copy startup-config {file | running-config | tftp}
copy tftp {file | running-config | startup-config |
https-certificate | public-key}
• file - Keyword that copies a specified file located in the ECN330-
switch’s flash memory or on a TFTP server. The command prompts
for the file name.
• running-config - Keyword that copies a file to or from the
current running configuration.
Command Function Mode Page
copy Copies a code image or an ECN330-switch
configuration to or from flash memory or a TFTP
server
PE 561
delete Deletes a file or code image PE 565
dir Displays a list of files in flash memory PE 566
whichboot Displays the files booted PE 567
boot system Specifies the file or image used to start up the
system
GC 568
To Next Page
Loading...
