Command Line Interface
562 1553-KDU 137 365 Uen D 2006-06-16
• startup-config - The configuration used for system
initialization.
• tftp - Keyword that copies a file to or from a TFTP server.
• https-certificate - Keyword used to copy an HTTPS
certificate from an TFTP server to the ECN330-switch.
• public-key - Keyword that copies an SSH key from a TFTP
server. (“Secure Shell Commands” on page 655)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.), and the maximum
length for file names on the TFTP server is 127 characters or 31
characters for files on the ECN330-switch. (Valid characters: A-Z, a-z,
0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the ECN330-switch supports
only two operation code files.
• The maximum number of user-defined configuration files depends on
available memory.
• The file “Factory_Default_Config.cfg” can be used as the source to copy
the factory default configuration file, but it cannot be used as the
destination.
• To replace the startup configuration, startup-config must be used
as the destination.
• For information on specifying an https-certificate, see “Replacing the
Default Secure-site Certificate” on page 134. For information on
configuring the ECN330-switch to
use HTTPS for a secure connection,
see “ip http secure-server” on page 651.
To Next Page
Loading...
