Command Line Interface
582 1553-KDU 137 365 Uen D 2006-06-16
Example
To specify 2 stop bits, enter this command:
7.5.30 disconnect
This command terminates an SSH, Telnet, or console connection.
Syntax
disconnect <session-id>
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Command Usage
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
Example
Related Commands
show ssh (section 7.7.29 on page 666)
show users (section 7.5.5 on page 549)
Console(config-line)#stopbits 2
Console(config-line)#
Console#disconnect 1
Console#
To Next Page
Loading...
