Command Line Interface
5811553-KDU 137 365 Uen D 2006-06-16
Command Usage
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not
be supported. The system indicates if the selected speed is not supported.
Example
To specify 57600 bps, enter this command:
7.5.29 stopbits
Use this command to set the number of the stop bits transmitted per byte. Use
the no form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Console(config-line)#speed 57600
Console(config-line)#
To Next Page
Loading...
