Command Line Interface
5891553-KDU 137 365 Uen D 2006-06-16
7.5.36 logging trap
This command enables the logging of system messages to a remote server, or
limits the syslog messages saved to a remote server based on severity. Use this
command without a specified level to enable remote logging. Use the no form to
disable remote logging.
Syntax
logging trap <level>
no logging trap
level - One of the syslog severity levels listed in the table on page 585.
Messages sent include the selected level up through level 0.
Default Setting
Disabled
Level 7 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
• Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
Example
Console(config)#logging trap 4
Console(config)#
To Next Page
Loading...
