Ericsson ECN330 - Page 647

Command Line Interface
6411553-KDU 137 365 Uen D 2006-06-16
7.7.5 radius-server host
This command specifies primary and backup RADIUS servers and
authentication parameters that apply to each server. Use the no form to restore
the default values.
Syntax
[no] radius-server <index> host {<host_ip_address> |
<host_alias>} [auth-port <auth_port>] [timeout
<timeout>] [retransmit <retransmit>] [key <key>]
• index - Allows up to five servers to be specified. These servers are
queried in sequence until a server responds or the retransmit period
expires.
• host_ip_address - IP address of server.
• host_alias - Symbolic name of server. (Maximum length: 20
characters)
• port_number - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)
• timeout - Number of seconds the ECN330-switch waits for a
reply before resending a request. (Range: 1-65535)
• retransmit - Number of times the ECN330-switch will try to
authenticate logon access via the RADIUS server. (Range: 1-30)
• key - Encryption key used to authenticate logon access for client.
Do not use blank spaces in the string. (Maximum length: 20
characters)
Default Setting
auth-port: 1812
timeout: 5 seconds
retransmit: 2
Command Mode
Global Configuration