Command Line Interface
6751553-KDU 137 365 Uen D 2006-06-16
7.7.34 dot1x system-auth-control
This command enables IEEE 802.1X port authentication globally on the
ECN330-switch. Use the no form to restore the default.
Syntax
[no] dot1x system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
dot1x re-
authenticate
Forces a re-authentication on specific ports PE 679
dot1x re-
authentication
Enables re-authentication for all ports IC 680
dot1x timeout
quiet-period
Sets the time that an ECN330 port waits after
the Max Request Count has been exceeded
before attempting to acquire a new client
IC 681
dot1x timeout re-
authperiod
Sets the time period after which a connected
client must be re-authenticated
IC 682
dot1x timeout tx-
period
Sets the time period during an authentication
session that the ECN330-switch waits before re-
transmitting an EAP packet
IC 682
show dot1x Shows all dot1x related information PE 683
Command Function Mode Page
To Next Page
Loading...
