Command Line Interface
676 1553-KDU 137 365 Uen D 2006-06-16
Example
7.7.35 dot1x default
This command sets all configurable dot1x global and port settings to their default
values.
Command Mode
Global Configuration
Example
7.7.36 dot1x max-req
This command sets the maximum number of times the ECN330 port will
retransmit an Extensible Authentication Protocol (EAP) request/identity packet
to the client before it times out the authentication session. Use the no form to
restore the default.
Syntax
dot1x max-req <count>
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Console(config)#dot1x system-auth-control
Console(config)#
Console(config)#dot1x default
Console(config)#
To Next Page
Loading...
