Command Line Interface
6771553-KDU 137 365 Uen D 2006-06-16
Command Mode
Interface Configuration
Example
7.7.37 dot1x port-control
This command sets the dot1x mode on a port interface. Use the no form to
restore the default.
Syntax
dot1x port-control {auto | force-authorized | force-
unauthorized}
no dot1x port-control
• auto – Requires a dot1x-aware connected client to be authorized
by the RADIUS server. Clients that are not dot1x-aware will be
denied access.
• force-authorized – Configures the port to grant access to all
clients, either dot1x-aware or otherwise.
• force-unauthorized – Configures the port to deny access to all
clients, either dot1x-aware or otherwise.
Default
force-authorized
Command Mode
Interface Configuration
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#
To Next Page
Loading...
