Command Line Interface
678 1553-KDU 137 365 Uen D 2006-06-16
Example
7.7.38 dot1x operation-mode
This command allows single or multiple hosts (clients) to connect to an 802.1X-
authorized port. Use the no form with no keywords to restore the default to single
host. Use the no form with the multi-host max-count keywords to restore
the default maximum count.
Syntax
dot1x operation-mode {single-host | multi-host [max-
count <count>]}
no dot1x operation-mode [multi-host max-count]
• single-host – Allows only a single host to connect to this port.
• multi-host – Allows multiple host to connect to this port.
• max-count – Keyword for the maximum number of hosts.
• count – The maximum number of hosts that can connect to a
port. (Range: 1-1024; Default: 5)
Default
Single-host
Command Mode
Interface Configuration
Command Usage
•The max-count parameter specified by this command is only effective
if the dot1x mode is set to auto by the dot1x port-control
command (page 677).
Console(config)#interface eth 1/2
Console(config-if)#dot1x port-control auto
Console(config-if)#
To Next Page
Loading...
