Command Line Interface
6811553-KDU 137 365 Uen D 2006-06-16
Related Commands
dot1x timeout re-authperiod (section 7.7.42 on page 682)
7.7.41 dot1x timeout quiet-period
This command sets the time that an ECN330 port waits after the Max Request
Count has been exceeded before attempting to acquire a new client. Use the no
form of this command to reset the default.
Syntax
dot1x timeout quiet-period <seconds>
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
To Next Page
Loading...
