Ericsson ECN330 - Page 688

Command Line Interface
682 1553-KDU 137 365 Uen D 2006-06-16
7.7.42 dot1x timeout re-authperiod
This command sets the time period after which a connected client must be re-
authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod <seconds>
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
Example
7.7.43 dot1x timeout tx-period
This command sets the time that an interface on the ECN330 waits during an
authentication session before re-transmitting an EAP packet. Use the no form
to reset to the default value.
Syntax
dot1x timeout tx-period <seconds>
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#