Command Line Interface
684 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the ECN330-switch.
• 802.1X Port Summary – Displays the current status of port access
control parameters for each interface, including the following items:
• Status – Administrative state for port access control. Displays
enabled if the dot1x port mode is set to Auto or Force-
Unauthorized. Displays disabled if the port mode is set to
Force-Authorized.
• Operation Mode – Allows single or multiple hosts, see section
7.7.38 on page 678).
• Mode – Dot1x port control mode (configurable, see section 7.7.37
on page 677).
• Authorized – Authorization status (displays yes or n/a—not
authorized).
• 802.1X Port Details – Displays detailed port access control
settings and the current status for each interface as described in the
preceding pages. The following items are displayed:
• reauth-enabled – Re-authentication (configurable, see section
7.7.40 on page 680)
• reauth-period – Re-authentication period (configurable, see
section 7.7.42 on page 682)
• quiet-period – The timeout before a port attempts to acquire a
new client (configurable, see section 7.7.41 on page 681)
• tx-period – The timeout before the ECN330-switch retransmits
an EAP packet (configurable, see section 7.7.43 on page 682)
• supplicant-timeout – Supplicant timeout (a fixed setting).
• server-timeout – Server timeout (a fixed setting).
• reauth-max – Maximum number of reauthentication attempts (a
fixed setting).
• max-req – The maximum number of retransmitted EAP request
packets (configurable, see section 7.7.36 on page 676)
To Next Page
Loading...
