Ericsson ECN330 - Page 726

Command Line Interface
720 1553-KDU 137 365 Uen D 2006-06-16
Configuration Guidelines
Follow these steps to create and bind an access map to an interface:
1. Create the required VLAN access map using the vlan access-map
command (section 7.8.18 on page 720), entering access-map configuration
mode.
2. Use the match command (section 7.8.19 on page 722) to specify the IP or
MAC ACL to specify the match criteria for the access map.
3. Use action command (section 7.8.20 on page 723) to drop or forward
traffic when a match is found.
4. Select a VLAN IP or VLAN MAC ACL mask using the access-list ip/
mac mask-precedence command (section 7.8.22 on page 726).
5. Configure the required mask with the IP mask command (section 7.8.23 on
page 727) or MAC mask command (section 7.8.24 on page 729).
6. Map the VLAN access map to an interface using the vlan filter
command (section 7.8.25 on page 731).
7.8.18 vlan access-map
This command creates a VLAN ACL for packet filtering and enters access map
configuration mode. Use the no form to remove the specified ACL.
Syntax
[no] vlan access-map <access-map_name>
access-map_name – Name of the access map.
(Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration