Command Line Interface
722 1553-KDU 137 365 Uen D 2006-06-16
7.8.19 match
This command sets the match criteria for one or more IP or MAC access lists.
Use the no form to remove the match parameters.
Syntax
match {ip address <acl-name> | mac address <acl-name>}
• ip address – Configures the access map to match packets
against an IP address access list.
• mac address – Configures the access map to match packets
against a MAC address access list.
• acl-name – Name of access list against which to match packets.
Default Setting
No match parameters are set
Command Mode
Access Map Configuration
Command Usage
•Use the match command to specify match criteria for the VLAN map. If
the packets match, they will be forwarded or dropped, depending on the
specified action.
• If more than one match command is entered for same access-map
entry, all of the match commands share the same action command.
• If the action is drop matching packets, first define the access map,
including configuring any access control list (ACL) names used in the
match clauses before binding the map to a VLAN, or all packets could
be dropped.
To Next Page
Loading...
