Command Line Interface
738 1553-KDU 137 365 Uen D 2006-06-16
Example
To specify port 4, enter the following command:
7.9.2 description
This command adds a description to an interface. Use the no form to remove the
description.
Syntax
description <string>
no description
string - A comment or description that identifies what is attached to
this interface. (Range: 1-64 characters)
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following example adds a description to port 4.
Console(config)#interface ethernet 1/4
Console(config-if)#
Console(config)#interface ethernet 1/4
Console(config-if)#description RD-SW#3
Console(config-if)#
To Next Page
Loading...
