Configuring the ECN330-switch
711553-KDU 137 365 Uen D 2006-06-16
CLI – Specify the hostname, location and contact information.
6.3.2 Configuring the ECN330-switch for Normal Operation or Tunneling
Mode
The system can be configured to operate in normal mode or one of the tunneling
modes used for passing Layer 2 traffic across a service provider’s metropolitan
area network, including IEEE 802.1Q tunneling (QinQ) or Layer 2 over MPLS
(L2MPLS).
Command Attributes
System Mode – Sets the ECN330-switch to operate in one of the following
modes:
• Normal Mode – The ECN330-switch functions in normal operating
mode. (This is the default operating mode.)
Console(config)#hostname R&D 5
Console(config)#snmp-server location WC 9
Console(config)#snmp-server contact Ted
Console(config)#exit
Console#show system
System Description: ECN330; SW version: CXC 132 8902 V1.2;
System OID String: 1.3.6.1.4.1.193.72.1400
System information
System Up Time: 0 days, 1 hours, 11 minutes, and 53.80
seconds
System Name: R&D 5
System Location: WC 9
System Contact: Ted
MAC Address (Unit1): 00-00-12-33-89-76
Web Server: Enabled
Web Server Port: 80
Web Secure Server: Enabled
Web Secure Server Port: 443
Telnet Server: Enable
Telnet Server Port: 23
Jumbo Frame: Disabled
POST Result:
Console#
To Next Page
Loading...
