Command Line Interface
780 1553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
power inline priority (section 7.13.4 on page 782)
7.13.2 power inline
This command automatically detects if a PoE-compliant device is connected to
the specified port, and turns power on or off accordingly. It can also be used to
force a port into test mode. Use the no form to turn off power for a port.
Syntax
power inline [auto | test]
no power inline
• auto - The ECN330-switch automatically detects if an EDA device
is connected to the port and turns power on or off accordingly.
• test - Forces the port into a test mode. In test mode the port
continuously attempts to detect if an EDA device is connected to the
port, but does not supply power.
Default Setting
auto
Command Mode
Interface Configuration
Command Usage
• Using the command without an argument enables port power in auto
mode (the same as the power inline auto command).
Console(config)#power mainpower maximum allocation 400
Console(config)#
To Next Page
Loading...
