Command Line Interface
826 1553-KDU 137 365 Uen D 2006-06-16
8. Enable or disable an EAPS domain: Before an EAPS domain can work, it
must be enabled using the enable command (section 7.16.8 on page 834).
When configuration is completed and the domain is enabled, it will start
running on the ring. To stop a domain running on an ring, it can be disabled
on any node using the disable command.
9. Unconfigure an EAPS ring port: Use the no port primary or no port
secondary command (section 7.16.5 on page 830) to unconfigure an
EAPS primary or secondary ring port for an EAPS domain.
10. Display EAPS status information: Use the show eaps command (section
7.16.10 on page 836) to display general EAPS status information or more
detailed EAPS status information. The output displayed depends on
whether the node is a transit node or a master node.
7.16.1 eaps domain
This command creates an EAPS domain and enters EAPS configuration mode
for the specified domain. Use the no form to delete an EAPS domain.
Syntax
[no] eaps domain <name>
name - Name of a specific EAPS domain. (Range: 1-32 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#eaps domain r&d
Console(config-eaps)#
To Next Page
Loading...
