Ericsson ECN330 - Page 833

Command Line Interface
8271553-KDU 137 365 Uen D 2006-06-16
Related Commands
show eaps (section 7.16.10 on page 836)
7.16.2 mode
This command configures the ECN330-switch as a master node or transit node
on the ring. Use the no form to delete an EAPS domain.
Syntax
mode {master | transit}
• master - Configures the ECN330-switch as the master node of the
EAPS domain. This node actively monitors ring integrity and sends
health check and state change messages to transit nodes. Only one
master node can be set for a domain.
• transit - Configures the ECN330-switch as a transit node in the
EAPS domain. Transit nodes receive master control messages,
detect ring topology changes, and send status messages to the
master node.
Default Setting
None
Command Mode
EAPS Domain Configuration
Command Usage
• The master node is the control node of the EAPS domain.
• The transit node will receive control messages from the master node to
synchronize the hello and fail timers. All other configuration parameters
for a transit node should be configured to be the same as that the EAPS
domain’s master node.