Command Line Interface
852 1553-KDU 137 365 Uen D 2006-06-16
Any untagged traffic entering a downlink port is tagged with the
Untagged VLAN ID (default 248). The embedded nodes can use
untagged frames to get information about the used management
VLAN.
For more information about the DMV, please refer the Management
VLAN Configuration Guide. Note that the ECN330-switch does not
have to be configured for the DMV. It automatically supports the
DMV for all embedded nodes.
• external - External Management VLAN provides management
access through the Gigabit Ethernet ports using tagged frames.
This interface represents the EAN to the outside network. By
default, it must be manually configured with an IP address for the
ECN330-switch, using the same management VLAN as that used
by the EDA network.
Uplink ports (25 - 27) are configured automatically with the External
Management VLAN ID (default 246). Any untagged traffic entering
an uplink port is tagged with VLAN ID 1 and silently dropped.
• native - Native Management VLAN is used internally to
terminate untagged traffic passed from or to the SBC (for example,
when using a QinQ tunnel).
• fsa - FSA Management VLAN provides management access
through the Fast Ethernet ports using tagged frames.
• vlan-id - ID of configured VLAN. (Range: 1-4094,
no leading zeroes)
Default Setting
• internal - VID: 247; Members: 1-24, 28 tagged
• dynamic - VID: 248; Members: 1-24 untagged, 28 tagged
• native - VID: 4093; Members: 28 untagged
• external - VID: 246; Members: 25-28 tagged
• fsa - VID: 249; Members: 1-24,28 tagged
Command Mode
Global Configuration
To Next Page
Loading...
