Command Line Interface
882 1553-KDU 137 365 Uen D 2006-06-16
Command Mode
Privileged Exec
Example
This shows that traffic entering Port 1 that matches the specifications for
protocol group 1 will be mapped to VLAN 2:
Configuring IEEE 802.1Q Tunneling
This section describes commands used to configure QinQ tunneling.
Table 96 IEEE 802.1Q Tunneling Commands
Console#show interfaces protocol-vlan protocol-group
Port ProtocolGroup ID VLAN ID
---------- ------------------ -----------
Eth 1/1 1 vlan2
Console#
Command Function Mode Page
system mode Configures the ECN330-switch to operate in
normal mode, QinQ mode, or L2MPLS mode
PE 552
show system mode Displays the ECN330-switch system mode PE 553
switchport mode
dot1q-tunnel
Configures an interface as a QinQ tunnel port IC 884
show dot1q-tunnel Displays information about QinQ tunnel ports PE 885
switchport dot1q-
ethertype
Sets the Tag Protocol Identifier (TPID) value of a
tunnel port
IC 885
address-monitor
qinq
Forwards traffic for the internal management
VLANs (VIDs 247-249) between the QinQ tunnel
port and the SBC
IC 887
To Next Page
Loading...
